Belden VFD Cables Provide Superior Electrical Performance and Reliability, Even in the Most Demanding Industrial Environments

Variable-frequency AC motor drive output cables are subject to harsh operating environments characterized by high voltage spikes, high noise levels and adverse environmental conditions. Typical cabling solutions for this application have been unshielded tray cables, single-conductor lead wire installed in conduit or continuously-welded armored cable. These solutions suffer from complex, costly installation and potential reliability problems. Belden Variable-frequency Drive (VFD) cables were designed and engineered to overcome these challenges.  

VFD cables carry power from AC drive systems to AC motors. As a result, these cables must handle not only the overall high power levels of the pulse-width modulated (PWM) signals, but also the extremely high voltage which can occur when standing waves develop on the conductors. This high voltage can cause corona discharges to occur between the conductors of conventional cables, causing damage not only to the cabling itself, but also to the motors, bearings, drives and related equipment. In turn, this damage can cause failure of the entire drive system, resulting in costly production downtime.

In addition to experiencing failures due to corona discharge and adverse environmental conditions, conventional VFD cabling is difficult and expensive to install. Armored cable and lead wire in conduit are cumbersome and require extremely large installation bending radii, making installation both time consuming and labor intensive. Yet they still do not solve noise and corona discharge problems, nor do they effectively address the high levels of noise generated by VFDs.

Belden’s MCM VFD cables provide a proven solution for motor-to-drive connections. The cables are essential in noise-sensitive applications or in any damp or wet environment where reflected wave voltages may degrade PVC/nylon conductors. These products are also suitable for use as shielded power cable for other solid state devices. Belden VFD cables provide superior common mode current protection, and help protect a system against the damage of reflected wave voltages and capacitively coupled currents, ensuring maximum safety and reliability.

Certified to Numerous Safety Standards (ratings vary by construction)

• 1000V UL Flexible Motor Supply
• 600V UL 1277 Type TC-ER
• 1000V CSA AWM I/II A/B FT4
• 1000V UL 2277 WTTC 
• 90C Wet/Dry
• Class I & II; Division 2 Hazardous Locations
• UL 1685 Vertical Tray Flame Test
• IEEE 1202/383 Vertical Tray Flame Test at 70,000 BTU/hour
• MSHA
• UL Direct Burial
• RoHS Compliant

• CE Approved

Belden Variable Frequency Drive cables are available in various standard lengths. Armored versions are also available. They are tested and approved for use by Rockwell Automation for the following AC drives: PowerFlex Series, Series 1305, Series 1336 Plus and Plus II, Series 1336 Impact and Series 1336 Force Field-Oriented Control. Belden VFD Cable is also appropriate for drives manufactured by: AA Electric, ABB, Baldor, Cutler-Hammer, Emerson Process Management, Fivestar Electric Motors, General Electric, Hitachi, Magnetek, Mitsubishi Electric Automation, Motion Industries, Quality Drive Systems, Robicon, Siemens, Square D, Toshiba and TB Woods.

Belden Classics - VFD Cables 600 V UL 1277 TC-ER  

VFD Cable with (3) Stranded Tinned Copper Conductors + Full-size Insulated Ground, Overall Beldfoil® + 85% Tinned Cooper Braid Shield, Full-size Drain Wire, XLPE Insulated Circuit Conductors, Black PVC Jacket; 1000V UL Flexible Motor Supply Cable