Supply Voltage and Current | 10 to 30V dc (10% max. ripple) @ 45 mA (exclusive of load) |
---|---|
Range | Opposed:60 m Non-polarized Retroreflective:12 m, range is specified using one model BRT-84 retroreflector Polarized Retroreflective:8 m, range is specified using one model BRT-84 retroreflector Diffuse:1.0 m |
Supply Protection Circuitry | Protected against reverse polarity, over voltage and transient voltages |
Output Configuration | Bipolar:One NPN (current sinking) and one PNP (current sourcing); light operate (LO) or dark operate (DO) selectable or configurable, depending on model |
Output Rating | 100 mA max. each output @ 25° C OFF-state leakage:
NPN:less than 200 µA @ 30V dc PNP:less than 10 µA ON-state saturation voltage:NPN:less than 1.6V @ 100 mA PNP:less than 2.0V @ 100 mA |
Output Protection Circuitry | Protected against output short-circuit, continuous overload, transient over-voltages and false pulse on power-up |
Output Response Time | Opposed:5 milliseconds ON/OFF All others:2 milliseconds ON/OFF |
Delay at Power-up | 100 milliseconds; outputs do not conduct during this time. |
Repeatability | Opposed:not applicable All others:500 microseconds |
Adjustments | Opposed, Polarized Retroreflective and Non-polarized Retroreflective:Selectable light/dark operate is achieved using the gray wire
Light Operate:Low (0 to 3V)* Dark Operate:High (open or 5 to 30V)* Diffuse:Light Operate:High (open or 5 to 30V)* Dark Operate:Low (0 to 3V)* Diffuse, Polarized Retroreflective and Non-polarized Retroreflective:Single-turn sensitivity(Gain) adjustment potentiometer*Note:Input impedance 10 k ohms |
Indicators | Large, oval LED indicator on back (Except Emitter):
Yellow ON steady:output conducting 2 LED indicators on top:Green and YellowGreen ON steady:power ON Green flashing:output overloaded (except receivers) Yellow ON steady:light sensed Yellow flashing:marginal excess gain (1.0-1.5x excess gain) |
Construction | PC/ABS housing with acrylic lens cover |
Environmental Rating | IP67; NEMA 6 |
Connections | 5-conductor 2 m or 9 m attached PVC cable, or 4-pin Euro-style quick-disconnect fitting. QD cables are ordered separately. |
Operating Conditions | Temperature:-20 to +70° C Relative humidity:90% @ 50° C (non-condensing) |
Vibration and Mechanical Shock | All models meet Mil. Std. 202F requirements. Method 201A (Vibration; frequency 10 to 60 Hz max., double amplitude 0.06-inch acceleration 10G). Also meets IEC 947-5-2 requirements: 30G, 11 milliseconds duration, half-sine wave. |
WORLD-BEAM QS30 Standard Series, dc models | 22.12.2014 - 1 Mb | İngilizce | Check Out |
Address | : | Oruçreis Mah. Tekstilkent Cd. Tekstilkent Ticaret Merkezi A8 Blok No:17/18/19 Esenler / Istanbul / Turkey |
Telephone | : | +90 212 210 76 46 |
Fax | : | +90 212 220 50 45 |
: | info@dacel.com.tr |